The Selfsat H22SCR+ is a compact and discreet flat satellite antenna featuring an integrated SCR/Unicable system and two separate Legacy outputs. It provides a smart alternative to a conventional satellite dish and is ideal where a less visible and more flexible installation is required.
Its combined output configuration allows up to four Unicable-compatible receiver tuners to operate through one coaxial cable, while two conventional satellite receivers or televisions can be connected to the separate Legacy outputs. The system therefore supports up to six independent tuners or users in total, depending on the receiver configuration.
The antenna provides reception performance comparable to a conventional 60 cm satellite dish, with a specified gain of 34.5 dBi at 12.7 GHz. It is suitable for receiving strong European Ku-band satellites within their respective coverage areas.
A comprehensive mounting kit is supplied, including a mast bracket, wall bracket, window bracket and stand. This makes the Selfsat H22SCR+ suitable for houses, apartments, balconies, motorhomes and other locations where a conventional round dish is difficult to install.
✅ Product Benefits
- Flat, compact and discreet satellite antenna
- Integrated SCR/Unicable system
- Four Unicable user bands through one coaxial cable
- Two separate Legacy outputs
- Supports up to six tuners or users in total
- Performance comparable to an approximately 60 cm dish
- Antenna gain of 34.5 dBi at 12.7 GHz
- Simplifies multi-receiver satellite installations
- Reduces the number of cables required
- Suitable for new and existing satellite systems
- Mast, wall, window and stand mounting options included
- Suitable for houses, apartments, balconies and motorhomes
- Discreet white construction
- Operating temperature from −40 to +60°C
👥 Support for up to Six Tuners
The Selfsat H22SCR+ has three signal outputs:
- 1 × SCR/Unicable output with four user bands
- 2 × Legacy outputs for conventional satellite receivers
The Unicable output can distribute satellite signals to up to four compatible tuners through a single coaxial cable. The two Legacy outputs can simultaneously supply two conventional receivers or tuners.
This provides support for up to six independent tuners in total. A receiver with two tuners normally uses two user bands or connections, so the number of physical receivers may be lower than six.
📡 Unicable/SCR Compatibility
The Unicable output provides four SatCR user bands:
- 1210 MHz
- 1420 MHz
- 1680 MHz
- 2040 MHz
Control is provided according to EN 50494. The connected receiver or television must support EN 50494 and be configured with one of the available user-band frequencies.
This version should therefore be described as a four-channel SCR/Unicable system. The supplied technical information does not confirm 24 user bands or EN 50607/JESS compatibility.
🎯 Ideal For
- Houses and terraced homes
- Apartments and balconies
- Offices and smaller properties
- Motorhomes and caravans
- Locations where a round satellite dish is undesirable
- Homes with multiple satellite receivers
- Televisions with integrated DVB-S2 tuners
- Unicable-compatible receivers
- Multi-tuner PVR receivers
- Upgrading existing satellite installations
- Installations where fewer coaxial cables are preferred
🔧 Installation
The antenna can be installed using the supplied mast bracket, wall bracket, window bracket or stand. Select the mounting method according to the installation surface, available space and clear line of sight towards the required satellite.
After installation, carefully adjust the antenna’s azimuth, elevation and polarisation. A professional satellite signal meter is recommended for achieving optimum signal strength and quality.
In a Unicable installation, each tuner must be assigned a unique user-band frequency. The same frequency must not be programmed into multiple tuners within the same Unicable system.
Before installation, confirm that the receiver or television supports EN 50494. Splitters and wall outlets connected to the Unicable line must be diode-isolated and suitable for satellite and Unicable distribution.
⚙️ Technical Specifications
Product type: Flat satellite antenna with integrated SCR/Unicable and Legacy distribution
Model: Selfsat H22SCR+
Alternative designation in the supplied information: H22D-SCR
Colour: White
Polarisation: Vertical and horizontal
Antenna gain: 34.5 dBi at 12.7 GHz
Equivalent conventional dish size: Approximately 60 cm
Low-band input frequency: 10.70–11.70 GHz
High-band input frequency: 11.70–12.75 GHz
Low-band LO frequency: 9.75 GHz
High-band LO frequency: 10.60 GHz
LO deviation at 25°C: ±1 MHz
LO stability from −40 to +60°C: ±3 MHz
LO phase noise at 1 kHz: Maximum −60 dBc/Hz
LO phase noise at 10 kHz: Maximum −75 dBc/Hz
LO phase noise at 100 kHz: Maximum −100 dBc/Hz
Noise figure: Typically 0.8 dB
Cross-polarisation isolation: Minimum 20 dB
1 dB compression point: Minimum 0 dBm
Output VSWR: Maximum 2.0:1
Power consumption: Maximum 250 mA at 13 V
Output connectors: 75 Ω F female
SCR/Unicable outputs: 1
Unicable user bands: 4
Legacy outputs: 2
Maximum tuner capacity: Up to 6 in total
Unicable standard: EN 50494
Unicable II/JESS EN 50607: Not confirmed by the supplied information
Operating temperature: −40 to +60°C
Dimensions, width × height × depth: Approximately 566 × 300 × 65 mm
Weight: Approximately 7.0 kg
⚙️ SCR/Unicable Output Specifications
User band 1: 1210 MHz
User band 2: 1420 MHz
User band 3: 1680 MHz
User band 4: 2040 MHz
Conversion gain outside AGC: Minimum 60 dB
Gain variation: Maximum 7.5 dB peak-to-peak
IF AGC output level in CW mode: −32 to −17 dBm
Control protocol: CENELEC EN 50494
⚙️ Legacy Output Specifications
Number of Legacy outputs: 2
IF output range: 950–2150 MHz
Conversion gain outside AGC: Minimum 55 dB
Gain variation: Maximum 7.5 dB peak-to-peak
IF AGC output level in CW mode: −16 to +25 dBm
Vertical polarisation: 10.5–14 V
Horizontal polarisation: 16–21 V
Low band: 0 kHz
High band: 22 kHz ±4 kHz
📦 Package Contents
- 1 × Selfsat H22SCR+ flat satellite antenna
- 1 × Integrated SCR/Unicable unit with four user bands
- 2 × Integrated Legacy outputs
- 1 × Mast bracket
- 1 × Wall bracket
- 1 × Window bracket
- 1 × Stand
- Installation instructions
- Screw set
- Installation tools according to the supplied package
Please note: Coaxial cable, F-connectors, satellite receiver, television, Unicable splitter, wall outlets and grounding equipment are not included.
🔧 Compatible Accessories
The Selfsat H22SCR+ can be combined with:
- EN 50494-compatible satellite receiver
- Television with DVB-S2 and EN 50494 Unicable support
- Diode-isolated Unicable splitter
- Unicable-compatible satellite wall outlets
- Satellite-grade coaxial cable
- Compression or F-connectors
- Weather protection for outdoor connections
- Satellite signal meter
- Grounding and equipotential-bonding equipment
⚠️ Important Information
- The product provides four Unicable user bands and two Legacy outputs.
- Maximum capacity is up to six tuners in total.
- The supplied information confirms EN 50494, not EN 50607/JESS with 24 user bands.
- Do not advertise this model as supporting 24 users without separate technical confirmation.
- Each Unicable tuner must be assigned a unique frequency.
- A twin-tuner receiver normally uses two user bands.
- Not all receivers support Unicable; confirm compatibility before ordering.
- Unicable splitters and wall outlets must be designed for satellite distribution.
- The antenna requires a clear line of sight towards the selected satellite.
- Reception depends on satellite coverage and the installation location.
- Confirm the receiver requirements before using the antenna with Allente or another television operator.
- Operator subscriptions, viewing cards and receivers are not included.
- Professional installation is recommended when uncertain.
